USER’S MANUAL
1. INTRODUCTION
The UPS is a extremely reliable standby uninterruptible power system designed to keep computers and peripheral devices such as
monitors, storage subsystems, modems, tape drives, etc performing from utility line failures which could result in damage of data In
the event of utility failure, the UPS supplies power to your equipment derived from a battery within the UPS and provides visual and
audible indicators which alert you to utility line failures therefore the user has ample time to save file and close operations Whenever
the UPS is plugged in, the UPS maintains the battery in a charged condition and serves to protect your equipment from surges and
noise brought from utility
The main features include:
Advanced equipment & data protection from blackouts, brownouts, sags, AC line noise and surges
Adjustable input power range settings to meet your power source requirement
Full analytical high performance micro processor control with true RMS synchronous calculation
Intelligent battery management for battery status, battery power saving & battery replacement control
DC direct start up capability, MS NT communication ready, complete diagnostic indication and control
2. INSTALLATION AND SAFETY INSTRUCTIONS
Receiving Inspection
Once you have received the UPS, you should remove and inspect the unit for shipping damage. If damage is found, immediately notiJ
fy the carrier and your dealer. The carton and foam materials in which the UPS was shipped to you were designed with great care to
provide protection from transportation related damage. You should keep both the shipping carton and the packing foam in case the
UPS must be returned to the factory for service (damages sustained in transit when shipped from the user are not covered under warJ
ranty).
Important Safety Instructions
[Instructions Importantes Concernant La Securite]
Save these instructions — This manual contains important safety instructions [conserver ces intructions. Cette notice contient des
instructions importantes concernant la securite.]
All safety and operating instructions should be read before operating your UPS. These UPS units are intended for use in a temperaJ
tureJcontrolled, indoor area free of conductive contaminants. Select a location which will provide good air circulation for UPS at all
times.
For the first time use, your unit should be plugged in (the power I/O switch does not have to be on) for at least 8 hours to
fully charge the battery.
CAUTION
A battery can present a risk of electrical shock, bum from high shortJcircuit current. Observe proper precautions. Une batterie peut
presenter un risque de choc eletrique, de brulure par transfer! d’energie. Suivre les precautions qui s’imposent.]
When replacing batteries use the same number and the following type batteries given in the Specifications section of this manual.
CAUTION — Proper disposal of batteries is required. Refer to your local
codes for disposal requirements. [ATTENTION: L’elimination des batteries est reglementee. Consulter les
codes locaux a cet effet.]
18
