ADJ Products, LLC - www.adj.com - Inno Spot LED Instruction Manual Page 13
ADJ Products, LLC - www.adj.com - Inno Spot LED Instruction Manual Page 14
Operating Modes: The Inno Spot LED can operate in three dif-
ferent modes. In each mode you can run the fixture as a stand
alone fixute or in a master/slave confiugration. This next section
will detail the differences in the operating modes.
• Sound Active mode -
The fixture will react to sound, chasing through the built-in programs.
• Show mode -
The fixture will run one of four shows that you choose.
• DMX control mode -
This function will allow you to control each individual fixtures traits
with a standard DMX-512 controller such as the Elation
®
Show
Designer.
™
Master-Slave Operation
This function will allow you to link up to 16
units together and operate without a controller. The units will be sound
activated. In Master-Slave operation one unit will act as the controlling
unit and the others will react to the controlling units programs. Any unit
can act as a Master or as a Slave.
1. Using approved DMX data cables, daisy chain your units togeth-
er via the XLR connector on the rear of the units. Remember the
Male XLR connector is the input and the Female XLR connector
is the output. The first unit in the chain (master) will use the female
XLR connector only - The last unit in the chain will use the male
XLR connector only. For longer cable runs we suggest a termina-
tor at the last fixture.
2. On the Master unit find your desired show and set that show by
pressing the ENTER button.
3. On the slave units
tap the MENU button until “
SLND
” is dis-
played, and Press ENTER. Choose either
“
SL 1
” or “
SL 2
” and
press ENTER. See page 10 for more info.
4. The slave units will now follow the Master unit.
Universal DMX Control:
This function allows you to use a Elation
®
universal DMX-512 controller to control the chases and patterns,
dimmer and strobe. A DMX controller allows you to create unique
programs tailored to your individual needs.
1. The Inno Spot LED is a ten DMX channel DMX fixture. See
pages 16-17 for detailed description of the DMX values and traits.
Inno Spot LED
Operation
Inno Spot LED
System Menu
To enter the OTIL (Home position adjustment) & Gobo wheel adjust-
ment submenu, press the ENTER button for at least 5 seconds. In
this submenu you are able to adjust the original position of the gobo
wheel and tilt (home position).
OTIL
- Adjustment of the home position.
1. Press the ENTER button for at least 5 seconds, then press the UP
or DOWN buttons so that “
OTIL
” is displayed, press ENTER.
2. Use the UP and DOWN buttons to make your adjustments, and
then press ENTER to confirm. Press the MENU button for one second
to exit.
OGOB
- Adjustment of the gobo wheel.
1. Press the ENTER button for at least 5 seconds, then press the UP
or DOWN buttons so that “
OGOB
” is displayed, press ENTER.
2. Use the UP and DOWN buttons to make your adjustments, and
then press ENTER to confirm. Press the MENU button for one second
to exit.
MENU
