USER’S MANUAL
3. PACKAGE INCLUDES
1) UPS — 1 pcs
2) Power cord — 1 pcs
3) Power cord for load connection — 1 pcs
4) RS232 cable — 1 pcs
5) Software CD — 1 pcs
6) Instruction manual — 1 pcs
7) RJ11 Phone Jack Cable — 1 pcs
8) Reserved fuse — 1 pcs
9) Warranty card — 1 pcs
Notice:
Power cord is built in for model POWER SMART L 2000, for POWER SMART L 3000 power cord will be optional. You must use
power cord with each core diameter not less than 1,5 mm
2
.
4. THE MAIN FEATURES
!
High performance of conversion.
!
Wide range input voltage.
!
Full digital microprocessor control.
!
Pure sine wave output.
!
User’s adjustable Output DIP switches allow you to select an accommodate Output voltage for your critical device.
!
Cold start function (DC power on).
!
Circuit Breaker for protecting the over current from the incoming AC utility.
!
Smart communication port (True RS-232).
!
Short Circuit and overload protection.
!
Advanced Input PFC control guarantees the PF performance and maximum energy efficiency.
!
SNMP adapter slot represents the advanced upgrade solution to achieve direct power management via internet world-wide.
!
Additional sockets for connection of external batteries.
!
Automatical choosing of the optimal cooling mode.
5. SERVICE AND STORAGE
Cleaning
Before cleaning, turn off the switch of the UPS. Unplug the UPS from the power outlet. Also unplug the battery cable for the long back up
time model.
Clean all surfaces with a soft, lint-free cloth that you have dampened in a mild solution of detergent and water. The cloth must not be too
wet.
Warning
Never spill water or cleaning fluid inside the unit. Should this happen accidentally, call your maintenance authority immediately.
Do not use scouring pads, steel wool, harsh chemical agents, or anything that can damage the surface of the unit.
Storage
If you plan to store the UPS, there is a risk that the battery might discharge to the point where is permanently discharged. To prevent this
from happening, follow these steps before storing the UPS:
a. Fully charge the battery before storing the UPS.
b. Recharge the battery for 24 hours at intervals not greater that 3 months.
14
