Eng
SMART L 1000/2000/3000
1. INTRODUCTION
The On-Line uninterruptible power supply (UPS) protects your sensitive electronic equipment from basic power problems such as power
failures, power sags, power surges, brownouts, line noise, and frequency variation, switching transient and harmonic distortion.
Power outages can occur when you least expect it and power quality can be erratic. These power problems have the potential to corrupt
critical data, destroy unsaved work sessions, and damage hardware – causing hours of lost productivity and expensive repairs. This UPS
is using the most advanced PWM technology, with the On-Line UPS, you can safely eliminate the effects of power disturbances and guard
the integrity of your equipment.
2. SAFETY INSTRUCTIONS
2.1. Inspection the Equipment
If any equipment has been damaged during shipment, keep the shipping cartons and packing materials for the carrier or place of purchase
and file a claim for shipping damage. If you discover damage after acceptance, file a claim for concealed damage.
To file a claim for shipping damage or concealed damage: 1) File with the carrier within 15 days of receipt of the equipment; 2) Send a copy
of the damage claim within 15 days to your service representative.
2.2. Precaution
Read the following precaution before you install the UPS.
SAVE THESE INSTRUCTIN. This manual contains important instructions that you should follow during installation and maintenance of the
UPS and batteries. Please read all instructions before operating the equipment and save this manual for further reference.
FOR THIS FIRST TIME USE, YOUR UPS SHOULD BE PLUGGED IN (THE POWER I/O SWITCH DOES NOT HAVE TO BE ON) FOR
AT LEAST 10 HOURS TO FULLY CHARGE THE BATTERY.
WARNING
!
To reduce the risk of fire, replace only with same type and rating of fuse.
!
The batteries used by this uninterruptible power system are recyclable. Proper disposal of the batteries is required. The batteries con-
tain lead and pose a hazard to the environment and human health if not disposed of properly. Please refer to local codes for proper dis-
posal requirement or return the unit to a factory authorized service center for battery replacement or disposal.
!
Intended for installation in a controlled environment. Refer to manual for environmental conditions.
!
When replacing batteries, use the same number and type of batteries.
DANGER
Battery supplies over 60 V. Risk of electric shock, Do not touch uninsulated battery terminals.
CAUTION
!
To prevent the risk of fire or electric shock, install in a temperature and humidity controlled indoor area, free of conductive contaminants.
!
Rick of electric shock. Do not remove cover. No user serviceable parts inside.
!
Refer servicing to qualified service personnel.
!
Risk of electric shock. Hazardous live components inside this UPS are energized from the battery supply even when the input AC power
is disconnected.
!
To avoid electrical shock, turn off the unit and unplug it from the wall before servicing the battery or installing a computer interface cable.
!
Do not dispose of battery or batteries in fire. The batteries may explode.
!
Servicing of Battery Bank Connection should be performed by service personnel knowledgeable of batteries and the required precau-
tions. Keep unauthorized personnel away from batteries.
!
A battery can present risk of electric shock and high short circuit current. The following precautions should be observed when working
on batteries.
!
Remove watches, rings, or other metal object.
!
Use tools with insulated handles.
!
Wear rubber gloves and boots.
!
Do not lay tools or metal parts on the top of batteries.
!
Disconnect charging source prior to connecting or disconnecting battery terminals.
!
Risk of electric shock. Battery circuit is not isolated from AC input; hazardous voltage may exist between terminals and ground. Test
before touching.
!
Do not attempt to power the UPS from any receptacle except a 2-pole 3-wire grounded receptacle.
!
Do not place the UPS near water or in environments of excessive humidity.
!
Do not allow liquid or any foreign objects to get inside the UPS.
!
Do not block air vents in front of the UPS or air exhausts on the back.
!
Do not place the UPS under direct sunshine or close to heat-emitting sources.
!
Do not plug appliances such as hair dryers into the UPS receptacles.
!
Do not disassemble the UPS.
!
The power socket should be installed near the equipment. It should be easily accessible to isolate it from AC input. To disconnect, pull
the plug from the receptacle.
13
