MEASUREMENT FOUNDATION
1
WINCH
Z 2500
Fig.6:
Use a test light to locate a suitable wire
Fig.7:
Remote socket installation
Step 4 - Mount the Connector for Remote (optional on some models)
WARNING:
TO PREVENT SERIOUS INJURY OR DEATH FROM
EXPLOSION
• Do NOT drill into gas tank.
• Verify the area is clear behind the mounting location before drilling.
• After determining the mounting location for the remote socket, drill
three holes and install. (see fig.7)
• Once the remote socket is mounted, route the two bullet terminal
wires back to where the contactor will be mounted. Splice the end of
the red wire to a key controlled accessory circuit of the ATV (use the
provided wire splice). Using a test light, locate a suitable wire from
the ATV key switch. The wire should only have power when the key is
in the “ON” position.
NOTE:
If installing both switches, both red wires MUST be spliced to
a key controlled accessory circuit of the ATV as described above.
