EN
page 32
4. OPERATION
4.1 Machine start-up
4.1.1 Start-up
•
Check if the pump suction fi lter is properly inserted in its seat in the wash-tank
bottom (see pict. 7).
This fi lter must be cleaned every 20 wash-cycles or whenever necessary.
DO NOT use the appliance without the fi lter.
•
Put the surface fi lters in place (see pict. 7).
•
Shut the dishwasher hood.
•
Turn the water valve “open".
•
Turn the main power switch ON.
•
The machine is on
STAND-BY
. In the
B
display, the message
STAND-BY
will
appear.
•
Turn the button
C
.
The machine start will be active when the
A
button will light in red and on the
B
display the
STAND-BY
message will be
off
.
The water fi lling of the wash-tank is done by pre-heating via the boiler. On the
B
display, the messages
FILLING WATER
and
HEATING
will alternate. Should the machines be equipped with the WRAS certifi ed Break Tank, the tank fi lling phase
is extended.
The display will read
HEATING
, till wash-tank and boiler will reach the set temperatures. During this process, the machine
will not allow any cycle selection or start.
If the machine is in standard confi guration, with hot water in-feed (50°C), with no extra power, the
A
button will light in
green after some 20 min.
Should the machine be equipped with integrated heat recovery system, must be defi nitely supplied with cold (10°C) water
in-feed. In this case the
A
button will light in green after some 45 min.
At the end, the
B
display will show the last used cycle.
3. CONTROL PANEL AND RELATIVE SYMBOLS OPERATION
A)
START push-button to start up cycle / select cycle
B)
Display
C)
Switching – On / STAND BY button
D)
Regeneration push-button (optional)
E)
Drain Push-button
pict. 7
STAND-BY
FILLING WATER
HEATING
Should the electrical supply cable get damaged it shall be changed by the Manufacturer, or his Authorized Service, or other
technician with equivalent qualifi cation, to prevent any risk.
2.4.2 Start-up
At installation engineer’s care.
