6
ENGLISH
– Apply the lubricating oil to the junctions between the fixed
and moving parts of the blades.
– To install the blade block first insert its lower part to the
installation place and then carefully press on the upper edge
of the blades until clicking to lock it (pic. 6).
– Let the trimmer operate for approximately 30 seconds to
spread the oil across the rubbing surfaces. After that remove
the surplus oil with a dry cloth or a paper towel.
Note:
– Lubricate the blades after every use of the trimmer.
– For lubricating the blades use only the oil (7), supplied with
the unit, or the oil intended for similar devices.
– Do not use vegetable oil or oil that includes solvents.
Solvents will evaporate, and the remaining thick grease may
slow down the blades motion.
INSTALLING THE TELESCOPIC ATTACHMENT (1)
– Before installing and removing the telescopic attachment (1)
switch the unit off by setting the switch (4) to the position
«0»; if the unit is powered by the power cord, unplug it.
– Match the ledges on the attachment (1) with the grooves on
the trimmer body and press on the attachment (1) with slight
effort downwards until the lock clicks.
– Adjust the attachment (1) position by turning the control
knob (3) clockwise/counterclockwise (pic. 3).
– The adjustment range of the universal attachment (1) is from
0.5 to 10 mm.
USING THE HAIR TRIMMER
– For cordless use of the unit, charge the battery fully follow-
ing the recommendations above.
– For the corded unit operation, insert the power cord (8) con-
nector into the socket (6) and connect the power cord (8)
plug to the mains (pic. 2).
– Turn the control knob (3) to set the attachment (1) to the
necessary position.
– Before the operation switch the trimmer on by setting the
power switch (4) to the position «I».
– Make sure that the unit operates normally and the blades
move smoothly. If there is excess oil on the blades, remove
it with a dry cloth.
– If you work with the trimmer connected to the mains, always
check the power cord condition, do not allow its multiple
twisting, periodically turn the trimmer off and straighten
the power cord.
– If you need to remove the universal attachment (1), switch
the unit off by setting the switch (4) to the position «0», then
remove the universal attachment (1) (pic. 3, 4).
IM VT-2553_70x130.indd 6
15.08.2017 14:09:51
