3
IMPORTANT
CAREFULLY READ THE FOLLOWING
INSTRUCTIONS BEFORE INSTALLING
THE UNIT AND MAKE SURE THAT THE
YELLOW AND GREEN GROUNDING
CONDUCTOR IS DIRECTLY CONNEC-
TED TO THE GROUND IN THE WELDING
LOCATION./
THE UNIT MUST NEVER BE OPERATED
WITHOUT PANELS AS THIS COULD BE
DANGEROUS FOR THE OPERATOR AND
COULD CAUSE SERIOUS DAMAGE TO
THE EQUIPMENT.
THE UNIT WORKS ONLY WITH INPUT
VOLTAGE OF 230Vac -50 Hz-1Ph.
THE INPUT CABLE IS ENERGIZED EVEN
WHEN THE MAIN SWITCH IS ON THE “0”
POSITION. THEREFORE, BEFORE SER-
VICING THE EQUIPMENT, MAKE SURE
THAT THE 2 POLE PLUG IS DISCON-
NECTED FROM THE LINE SOCKET.
THIS WELDER CAN BE USED ONLY
WITH DIESEL GENERATING SETS WITH
POWER HIGHER THAN 6 KVA AT 220 V
50 HZ. (except for units supplied at 110V)
1.0 INTRODUCTION
1.1 EQUIPMENT IDENTIFICATION
" 1
3
usually appear on a nameplate attached to
& !
have a control panel such as gun and cable
-
tion or part number printed on the shipping
$
1.2 RECEIPT OF EQUIPMENT
When you receive the equipment, compare
it with the invoice to make sure it is complete
and inspect the equipment for possible dama-
0
/ 9!
should your machine not work properly, con-
sult the section on TROUBLE SHOOTING in
'
2.0 SAFETY WARNING
2.1 GENERAL INSTRUCTIONS
This manual contains all the necessary in-
structions for:
- the installation of the equipment;
- a correct operating procedure;
<
Therefore, be sure this manual is carefully
read and understood by the maintenance
2.2 LOCATION
Welding processes of any kind can be dange-
rous not only to the operator but to any person
situated near the equipment if safety and opera-
Therefore the owner and the operator must
be aware of all possible risks so that they
may take the necessary safety precautions to
/ !/
The main precautions to be observed are:
- Operators should protect their body by
! =-
protective clothing,
without pockets or
<
Oil or grease should
be carefully removed
from all articles, be-
! >-
rators should also
wear closed safety
boots with steel toe
caps and with rubber
1 # ?3
?
@
J + X
[ +
\ # /
- Operators should wear a non-
= ! -
signed so as to shield the neck and the face,
"
!
adequate to the welding process and current
) ! /
clean, and immediately replaced if they are
/ / 1#@3 ' -
ce to install a pane of transparent glass on
top of the adiactinic glass, between it and the
#?
