Table 2-2
Jetdirect menus (continued)
Menu item
Sub-menu item
Sub-menu item
Values and Description
802.1X
Reset
802.1X
settings to factory defaults.
No
(default): Retain current
802.1X
settings.
Yes
: Reset
802.1X
settings to factory defaults.
Enable Wipe
Most configuration settings are erased during a cold
reset. However, you can indicate whether to also
erase stored digital certificates.
Yes
: Erase all stored digital certificates during a cold
reset.
No
(default): Do not erase stored digital certificates
during a cold reset.
Reset Security
Specify whether the current security settings on the
Jetdirect server will be saved or reset to factory
defaults.
No
(default): The current security settings are
maintained.
Yes
: Security settings are reset to factory defaults.
Link Speed
The link speed and communication mode of the
Jetdirect server must match the network. The
available settings depend on the product and
installed Jetdirect server. Select one of the following
link configuration settings:
CAUTION:
If you change the link setting, network
communications with the Jetdirect server and
network product might be lost.
Auto
(default): The Jetdirect server uses auto-
negotiation to configure itself with the highest link
speed and communication mode allowed. If auto-
negotiation fails, either the
100TX Half
value or the
10T Half
value is set depending on the detected link
speed of the hub/switch port. (A 1000T half-duplex
selection is not supported.)
10T Half
: 10 Mbps, half-duplex operation.
10T Full
: 10 Mbps, full-duplex operation.
100TX Half
: 100 Mbps, half-duplex operation.
100TX Full
: 100 Mbps, full-duplex operation.
100TX Auto
: Limits auto-negotiation to a maximum
link speed of 100 Mbps.
1000T Full
: 1000 Mbps, full-duplex operation.
16
Chapter 2 Control panel
