12
Figure 2-1
2.1.2 VTO6000CM and VTO6100C
Before installing the bracket or flush mount box, cables in the wall shall be led through the
bracket or flush mount box.
Try not to install VTO6100C onto an iron door directly. Otherwise, signals may be shielded
and card induction may be poor.
Step 1 Dismantle M3 screws at the bottom of VTO and take off the decorative cap.
Step 2
Connect cables. Please refer to “1.2.2 Rear Panel” for details.
Step 3 Fix the bare device onto 86 box with M4 screws. Screw holes are located in Points 3 as
shown in the figure.
Step 4 To strengthen product firmness, after 86 box is in place, tighten it with ST3.0 screws in
Points 6 as shown in the figure.
Step 5 Install the decorative cap onto the bare device, and fix it with M3 screws.
