12.
Electric convector
EN
6. SERVICE
ATTENTION!
See “Rules for safe operation and installation of electric convector”
In the process of using an electric convector on the intake, outlet grill or on the device may appear
dust or other contamination. To preserve the health and appearance of the device must be reg-
ularly cleaned from dust and dirt. Before cleaning the external surfaces of the electric convector,
disconnect the appliance from the mains and allow it to cool completely. Clean the outside of the
appliance with a damp, soft cloth and then wipe dry and allow the device to dry completely. Do not
use abrasive cleaning agents. Do not damage the appliance with a sharp object, as scratches on
painted surfaces can cause rust.
Troubleshooting
Possible causes
Removal
Electric convector is connect-
ed to the mains, switch handle
Mode is set to heating but con-
vector does not work.
•
No power.
•
Violated contacts in the wir-
ing diagram of the circuit.
•
Defective switch modes
•
Check whether the power
supply is disconnected from
the device and, if necessary,
post power to the appliance.
•
Restore reliable connection
contacts.
•
Refer to a specialist repair
service center Hyundai.
Electric convector is connect-
ed to the mains, switch handle
modes of operation is set to
the heating, but the heating is
not going on.
•
The thermostat is set to tem-
perature lower than in the
room.
•
Temperature limiter parted
electrical circuit and shut off
the heating elements.
•
Defective switch modes.
•
Defective power relay.
•
Faulty thermostat.
•
Defective heating element.
•
Faulty temperature limiter.
•
Set the thermostat to a
higher temperature heat the
room, turning the thermostat
knob clockwise.
•
Ensure that the air inlet or
outlet grill is not blocked by
foreign objects and wait for
the inclusion of the tempera-
ture limiter, after the body of
the device to cool.
•
Refer to a specialist repair
service center Hyundai.
