1
Read Me First
About the DUO-CAPTURE mk2’s [COMPUTER/TAB] Switch
The [COMPUTER/TAB] switch located on the bottom panel needs to be placed at the setting that’s
appropriate for the device to which you’re connecting the DUO-CAPTURE mk2.
Switch position
Connected device
TAB
For connecting an iPad. Refer to “Using the DUO-CAPTURE mk2 with an iPad” (p. 2).
Driver installation is not necessary.
COMPUTER
For connecting a computer. Refer to “Using the DUO-CAPTURE mk2 with a Computer” (p. 1).
You must install the driver in your computer.
Using the DUO-CAPTURE mk2 with a Computer
2
1
Bottom panel
Rear panel
1.
Set the DUO-CAPTURE mk2’s [COMPUTER/TAB] switch to the “COMPUTER” position.
2.
Connect the DUO-CAPTURE mk2 to the computer.
MEMO
If you want to connect the DUO-CAPTURE mk2 to a computer in which the USB driver has not been installed, disconnect the DUO-CAPTURE mk2’s
USB cable from the computer, and install the USB driver in the computer as described in the section “Driver Installation” in the DUO-CAPTURE
owner’s manual.
DUO-CAPTURE mk2
Bottom panel
*
5
1
0
0
0
3
1
5
3
0
-
0
1
*