Operation
8
8
Operation
General operation
Press the POWER button to turn the unit
on. Press and hold the button again to turn
the unit off.
Turning the unit on/off
When first using the device or after
replacing the car battery, you must reset the
unit. Press the RESET button (hole) with a
pointed object (such as a ballpoint pen) to
set the unit to its initial state.
When some errors occur, you can also
press the RESET button to return to factory
settings, but note that it will erase clock
setting and some memorized functions.
Resetting the unit
Press the MODE button repeatedly to
select between Radio, AUX or USB
modes. Operation modes are indicated on
the display. The USB mode is not
available unless a USB storage device is
connected.
Mode selection
Adjust the volume by rotating the
VOLUME knob.
Press the DISP
button to mute the sound.
Volume control
Press the SELECT/VOLUME knob
repeatedly to select a parameter: BAS
(bass) => TRE (treble) => BAL (balance) =>
FAD (fader) => LOUD ON/OFF => EQ
(equalizer) => STEREO => DX(distance)/
LOC(local) => VOL(volume).
Rotate the knob to adjust each mode.
• Bass/Treble: from -7 to +7;
• Balance: -10 (left) to +10 (right);
• Fader: from -10 (rear) to +10 (front).
• Loudness: see “Loudness” paragraph
below
• EQ: select POP/CLASS/ROCK or
OFF.
When equalizer is in any mode except OFF,
bass and treble are not adjustable.
Sound settings
Activating this feature will enhance bass
and treble frequencies when listening to
music at low volumes.
Loudness
AUX-in jack is intended for connecting an
external audio equipment to amplify the
sound. If connection is made correctly, the
audio signal from the external source will be
transmitted through the acoustics of the
head unit. This enables to adjust the volume
and quality of the sounding. For example,
you can connect an MP3-player to listen to
tracks using the car acoustic system.
AUX input
Press
and hold
the DISP button
to show
the current time on the display for 3 seconds.
In this mode press and hold the DISP
button again. The time will start to flash.
Rotate the VOLUME knob to select the
current hour and minutes and press the
SEL
ECT
button to confirm.
Time display
