9
English
1. Turn the ignition on.
2. Enter the first digit of the current PIN code by pressing the Emergency disarm button
as many times.
3. Turn the ignition off/on.
4. Enter the second digit of the set PIN code by pressing the Emergency disarm button
as many times..
5. Turn the ignition off/on. If the correct PIN code was entered, the siren will chirp
twice confirming your entering the Transmitter programming mode.
6. Push button 1 of the transmitter. The siren will chip once confirming the transmitter
code recording.
7. Turn the ignition off and press the Emergency disarm button or wait for 15 seconds,
there will be two chirps confirming you have quit Transmitter programming.
CAUTION! If you have enabled AntiBhijack by programming, then for
memorising new transmitters you should turn on the ignition (1), then first enter
the PIN code to disable AntiBhijack, then wait for a chirp and a flash confirming
AntiBhijack disabling, and then without turning the ignition off proceed to
transmitter programming (2) i. e. enter the PIN code once again.
Feature programming.
To change a PIN code value, erase the transmitters you no longer need from the system
memory, or change the settings of programmable features, you should first perform
transmitter programming (see above) using a transmitter already known by the system.
Then proceed as follows:
1. Complete transmitter programming and turn the ignition on.
2. Enter the number of program switches group by pressing the Emergency disarm
button as many times (first digit). A siren chirp will confirm each push of the button.
3. Turn the ignition off/on.
4. Enter the number of switch within the group (second digit) by pressing the
Emergency disarm button as many times. A chirp will confirm each button push.
5. The feature current status is indicated by the system LED, which is lit if the feature is
enabled or is out if it is disabled.
6. To enable a feature press button 1 of the transmitter, to disable it press button 2.
7. To exit the Feature programming mode, turn the ignition off or wait several seconds
for a double siren chirp. To proceed with programming, turn the ignition on without
waiting for a chirp and resume from step 2.
