8
EN
3 Before use
Caution
•
Use the controls only as stated in this user manual.
Always follow the instructions in this chapter in
sequence.
If you contact the Consumer Care, you will
be asked for the model and serial number of
this apparatus. The model number and serial
number are on its bottom. Write the numbers
here:
Model No.: __________________________
Serial No.: ___________________________
Install the car audio system
These instructions are for a typical installation.
However, if your car has different requirements,
make the adjustment accordingly. If you have
any question regarding installation kits, consult
your local retailer.
Caution
•
This system is designed for negative ground (earth) 12V
DC operation only.
•
Always install this system in the car dashboard. Other
locations can be dangerous as the rear of the system
heats up during use.
•
To avoid short-circuit: before you connect, make sure
that the ignition is off.
•
Make sure that you connect the yellow and red power
supply leads after all other leads are connected.
•
Make sure that all loose leads are insulated with electrical tape.
•
Make sure that the leads do not get caught under
screws iron parts that will move (e.g. seat rail).
•
Make sure that all ground (earth) leads are run to a
common ground (earth) point.
•
Use only the supplied mounting hardware for a safe
and secure installation.
•
Improper fuses can cause damage or fire. When you
need to change the fuse, consult a professional.
•
When you connect other devices to this system, make
sure that the rating of the car circuit is higher than the
total fuse value of all the connected devices.
•
Never connect speaker wires to the metal body or chassis
of the car.
•
Never connect speaker wires with stripes to one another.
Connect wires
The ISO male connectors are not supplied.
Caution
•
Make sure that all loose leads are insulated with
electrical tape.
1
Check the car’s wiring carefully and
connect them to the ISO male connectors.
Connector
Connect to
1 Yellow wire
The +12V car battery
which is live at all times
2 Blue/White wire The electric antenna
control lead or power
supply lead of the
antenna booster. If there
is no electric antenna
or antenna booster, or
it is manually operated
telescopic antenna, it is
unnecessary to connect
this lead.
3 Black wire
A metal surface of the
car. Connect the black
ground (earth) lead
before connecting the
yellow and red power
supply leads.
a
b
c
d
e
f
g
h