7
What water to use?
• Your appliance has been designed to use untreated tap water.
Do not use pure demineralised or pure distilled water, water from clothes dryers, scented or softened water, rain water,
filtered, bottled or boiled water, water from refrigerators, batteries or air conditioners as these may damage the appliance.
These types of water contain organic waste, mineral elements that become concentrated when heated and cause spitting,
brown staining, leaking or premature wear on your appliance. If your water is very hard, mix 50% untreated tap water
with 50% distilled water (available in hardware stores). This water contains organic waste materials or minerals that
concentrate under the effect of heat and cause spitting, brown colouring or premature ageing of your appliance.
SAVE THESE INSTRUCTIONS
Environment protection first !
i
Your appliance contains valuable materials which can be recovered or recycled.
Leave it at a local civic waste collection point.
Problems with your garment steamer?
PROBLEM
POSSIBLE CAUSES
SOLUTIONS
There is no steam.
The appliance is not plugged in, or not
switched on.
Check that your appliance is correctly
plugged in and switched on.
The water level is too low.
Unplug your appliance and refill it.
The steam pump has not been primed.
Press the steam trigger continuously
for a few seconds to begin steaming.
You are using the appliance for the first
time.
Press the steam trigger continuously
for a few seconds to begin steaming.
The water tank is not fully in place.
Ensure that stopper is closed and
that the water tank snaps when put
into place.
The appliance is on standby mode.
PLEASE REFER TO THE ‘STANDBY’
section.
The appliance does not
heat.
It is not plugged in, or not switched on.
Plug in your appliance and switch on.
The appliance is on standby mode.
PLEASE REFER TO THE ‘STANDBY’
section.
Water leaks.
The water tank is not fully in place or the
stopper is not closed properly.
Ensure that stopper is closed and
that the water tank snaps when put
into place.
Steam rate decreases.
Scale has built up in the appliance.
Refer to ‘EASY DESCALING’ section in
instructions for use.
The steam leaves stains
on the fabric or the
appliance spits
You are using water with additives.
Never add any additive in the water
tank.
The appliance has not been cleaned
enough after the descaling operation.
Read carefully the ‘EASY DESCALING’
section in instructions for use.
You are using other liquids than white
vinegar to descale the product.
Use only white vinegar during ‘ANTI
CALC’ procedure.
Appliance steams
continuously.
The steam trigger is on the lock position.
Unlock the steam trigger.
