CAUTION!!! High sound pressure can damage your health!
Please use the common sense when controlling volume!
2
+
2
Ohm
4
+
4
Ohm
0,5 Ohm
0, 5 Ohm
2
1+1
Ohm
0
,
1
25
Ohm
Voice coil
Total impedance
EN
Connect the head unit (HU) to low-level inputs of the amplifier using RCA cable. Connection of the head unit
and remote control (optional).
5 . W I R I N G D I A G R A M S
S T A N D A R D C O N N E C T I O N D I A G R A M
Connect the speaker cables from the plus and minus terminals of the speakers to the respective outputs on the amplifier
terminal marked with SPEAKER, as shown at the diagram. To connect the power supply the power wires with the diameter of 4
AWG (21.2 mm²) should be provided. The fuse is placed in the holder and fixed in the cable cut. One end of the cable is connected
to the positive terminal of the battery, the second one – to the amplifier terminals marked with + 12V. Be sure to use a fuse with
the parameters suffcient for use in the system.
The length and diameter of the grounding cable must conform to the length and diameter of the cable + 12V. Connect
one end to the negative terminal of the battery and the other end of the grounding cable to the terminals marked with
GND.
For amplifiers with RMS power less than 1000 watts, the GND terminal can be connected to the car body.
The two MFC amplifiers connected to 2 ohms may be used for the serial connection.
The minimum operating resistance of one MFC model is 1 ohm.
In a series connection of 2 pcs MFC, the minimum resistance is 2 ohms.
Please read the following steps for accurate connection of the circuit in accordance with the scheme for
proper connection.
Amplifier connection:
Master: It is a master amplifier connected directly to the head unit (HU).
Slave: It is a slave amplifier connected to the output of the master amplifier.
B R I D G E C O N N E C T I O N D I A G R A M
7
