ADJ Products, LLC - www.adj.com - Zipper Instruction Manual Page 10
ADJ Products, LLC - www.adj.com - Zipper Instruction Manual Page 11
sensitive, and 100 being the most sensitive.
3. When you have found your desired setting press ENTER to
confirm.
DNST
- This mode can be used as a precaution mode,
that in case the DMX signal is lost, interrupted, or power is
lost, the operating mode chosen in the setup is the running
mode the fixture will go into when the DMX signal is lost. You
can also set this as the operating mode you would like the
unit to return to when power is applied.
1. Press the MENU button until “
DNST
” is displayed, and either
“
MASL
”, “
BLND
”, or “
LAST
” will be displayed beneath.
2. Press ENTER and the bottom choice will begin to flash. Use
the UP or DOWN buttons to choose an operating mode you
would like the unit to start up in when power is applied or the
DMX signal is lost.
• MASL (Master-Slave) - If the DMX signal is lost or power is
applied, the unit will automatically go into Master Slave mode
and run a built-in show.
• BLND (Blackout) - If the DMX signal is lost or interrupted, the
unit will automatically go into stand by mode.
• LAST - If the DMX signal is lost or interrupted the fixture will
stay in the last DMX setting. If power is applied and this mode is
set, the unit will automatically go into the last DMX set up.
3. Press ENTER to confirm your desired set up.
DIND -
In this mode you can select the dimmer curve.
1. Press the MENU button until “
DIND
” is displayed, press
ENTER.
2. The current dimmer curve setting will be displayed.
Zipper
System Menu
will now have contrast movement to each other.
SHND: SH
0
-
SH16
- Show modes 0-16 (Factory
programs). Show mode can run with or without sound
active mode active.
1. Press the MENU button until “
SHND
” is displayed, press
ENTER.
2. “Sh X” will now be displayed, “X” representing a number
between 0-16. Programs 1-16 are factory programs, while “Sh
0” is random mode. Press the UP or DOWN buttons to find your
desired show.
3. When you have found your desired show press ENTER, then
press and hold the MENU button for at least 3 seconds to acti-
vate. After you have set your desired show, it can be changed
at any time using the UP or DOWN buttons.
SOUN -
Sound Active mode.
1. Press the MENU button until “
SOUN
” is displayed, press
ENTER.
2. The display will show either “
ON”
or
“OFF
”. Press the UP or
DOWN buttons to select “
ON
” to activate sound active mode,
or “
OFF
” to deactivate sound active mode.
3. Press ENTER, then press and hold the MENU button for at
least 3 seconds to activate.
SENS -
In this mode you can adjust the sound sensitiv-
ity.
1. Press the MENU button until “
SENS
” is displayed, press
ENTER.
2. A number between 0-100 will be displayed. Press the UP or
DOWN buttons to adjust the sound sensitivity. 0 being the least
Zipper
System Menu
