52
30 cm
30 cm
INSTALLATION
The selection of the location
Install the air conditioner on a plat surface where the air openings will not be covered. The appliance should be installed is a spacious room.
A minimum clearance of 30 cm from a wall or other obstacles should be kept.
Duct installation
A) Temporary
1. Attach one end of the duct to the air exhaust outlet
(H)
and fix it in the
direction of the arrow as shown in the picture. Be sure to fix thoroughly.
2. Attach the other end of the duct to adaptor B (as show in the picture).
3. Put the end of the duct /outlet/ to nearby window.
The length of the duct can be altered by extending or compressing it.
It is recommended to keep the duct length to a minimum.
Keep the duct
in a horizontal position during installation, do not extend the duct or
attach other air outlets. Failure risk.
B) Permanent
1. Attach one end of the duct to the air exhaust outlet
(H)
and fix it in the
direction of the arrow as shown in the picture. Be sure to fix thoroughly.
2. Install the adaptor A onto the wall using 4 expansion plugs and screws.
Be sure to fix thoroughly. (See picture).
3. Attach the other end of the duct to adaptor A.
4. Cover the hole using the adaptor cap when not in use.
Properly installed ducts are shown in the picture (if you install the ducts onto
a wall, the height of the installation should be between 30 and 120 cm).
NOTE: Do not over bend the duct.
An example of an improperly installed duct. This may cause failure of the air
conditioner or its improper functioning.
Window installation kit
The air conditioner set is equipped with a window slider designed to fit “verti
-
cal” or “horizontal” window applications. It facilitates the installation of the
air outlet duct. However,
it may be necessary to modify some aspects of
the installation procedure for certain types of windows.
Please follow
the instructions in the pictures below concerning the minimum and maximum
window openings.
Expansion
plug position
Adaptor A
The maximum height
of the air exhaust duct
installation is
120 cm
The minimum height of
the air exhaust duct in
-
stallation is
30 cm.
Horizontal window
Window slider kit:
Min: 67,5 cm
Max: 123 cm
Vertical window
Window slider kit:
Min: 67,5cm
Max: 123cm
NOTE: If the window opening is less than the above-mentioned minimum length of the window slider kit, cut the part with the hole
in it to fit for the window opening. Never cut out new holes in the window slider kit.
