www.fubag.ru
O
m
perator's
anual
-
-
4
5. Shade guide
The shade number can be set manually between DIN 9-13. Check the Shade Guide Table to
determine the proper shade number for your application. Select a shade number by turning the
shade knob until the arrow points to the required setting.
6. Adjusting
For your safety and to insure that your Auto-Darkening filter Welding Helmet operates correctly,
please read the
thoroughly and consult a qualified specialist before use.
Operator's Manual
ARC CURRENT, A
WELDING PROCESS
MMA
MIG (heavy)
MIG (light)
TIG
MAG/CO
SAW
PAC
PAW
Fig.1
TOP
1 Adjusting the fit of the helmet
.
- The overall circumference of the headband can be made
larger or smaller by rotating the knob on the back of the
headband. (See adjustment "Y" in fig.1) This can be done
whil wearing the helmet allow
just the right tension to be
set
.
- If the headband is riding too high or too low on your head
adjust the strap which passes over the top of your head. To do
this release the end of the band by pushing the locking pip out
of the hole in the band.
and push the locking pip
through the nearest hole (See adjustment "W" in fig.1).
- Test the fit of the headband by lifting up and closing down the
helmet a few times. f the headband moves
re-
adjust it until it is stable.
e
ing
. This way the helmet is kept firmly on the head without
being too tight
Adjust the width of the band by sliding
two ends further or closer apart
I
when tilted,
