Burst of steam feature does not work
The water tank must be at least 1/4 full .Temperature must be set to steam position. Iron should be in the horizontal
position. Allow a short pause between shots. Be sure to fully depress the
burst of steam
button.
Spry mist feature does not work
The water tank must be at least 1/4 full. Fill the iron as described in the section “Filling the water tank”.
Iron is leaking
The steam switch should be set to the appropriate position. The heating controller should be in minimum position.
Specification.
Model: USI-284/285
Power supple: 230 V ~ 50 Hz
Power: 2200 W
The head office of the manufacturer : «UNIT Handelsgesellschaft G.m.b.H.»
131, Gersthofer Str., A-1180, Vienna, Austria
Exported by: «UNIT Electronics (H. K.) Limited»
3905 Two Exchange Square, 8 Connaught Place,
Central, Hong Kong
Made in People’s Republic of China (P.R.C.)
This appliance is to be stored and used under the following conditions: temperature – not less than
+5°C; relative humidity - not higher than 80%; aggressive impurities in the air: not allowable.
As the Manufacturer is constantly working on the improvement of its products, the design and
technical specifications are subject to change without prior notice.
