47
The electrical outlet must be protected by a 16A safety cut-out switch.
The connection between the device and the electrical network may employ a 3 meter
long (max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs
or gangs is prohibited because of the danger of fire that is involved with this.
Make sure that the power cable is undamaged and has not been installed under the
device or over hot or sharp surfaces.
The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. Operations using an electrical outlet
without a protective conductor are prohibited. If in doubt, have the house installation
checked over by a qualified electrician. The manufacturer cannot be made responsible
for damages that are caused by a missing or damaged protective conductor.
12.7 Warning notices
Attention. Danger due to hot surface!
►
Do not touch the hot surfaces of the device. Danger of burns!
►
Do not set or lay any items on the device.
12.8 Rating plate
The rating plate with the connection and performance data can be founded on the bottom
of the unit.
13 Operation and Handing
This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
Warning
►
Do not leave the device unsupervised when it is in operation, so that you can intervene
quickly in the event of dangers.
