4
ENGLISH
• The unit is intended for household usage
only; usage for commercial purposes is
prohibited.
Preparation for operation
• Unpack the unit.
• Before you connect the unit to the mains,
make sure that the voltage specified on
the unit corresponds to the voltage in
your home socket.
• Carefully wash all the removable parts,
which will contact with products, and dry
them.
Note: Be carefully while holding the
shredding sieve; its surface is very
sharp.
• Wash vegetables/fruits and cut them into
pieces, which will easily pass into the
cover throat of the unit.
• While extracting juice from stone fruits
(for instance cherry, peach etc.) remove
pits from the fruits.
Making juice
• Put the unit on the stable dry and flat sur-
face.
• Before assembling, make sure that the
unit is switched off and unplugged.
• Set the juice tank (5) on the motor unit
(9).
• Set the shredding sieve (4) in the juice
tank (5.
Note: - Do not use the shredding sieve
if it has any defects.
• Set the cover (3) on the juice tank (5).
• Set the juice container (8).
• Put a container (11) under the pouring
spout (6).
• Set the clamps (7) vertically, fixing the lid
(3).
• Insert the plug into the socket.
• Switch on the juicer by setting the switch
(10) to the “1/low speed” position or to
the “2/high speed’ position.
• Use the “*/Pulse” mode for short-time
operation of the juicer at the maximal
speed.
Note:
- “1/low speed” - is used to extract
juice from soft vegetables/fruits (to-
matoes, pears, strawberry, oranges,
plums, grapes, pumpkin, onion, cu-
cumbers etc.).
- “2/high speed” - is used to extract
juice from hard vegetables/fruits
(artichoke, carrot, apples, pepper,
beetroot, potatoes, pineapples, veg-
etable marrows, celery, spinage, dill,
kurrat etc.).
- “*/Pulse” is the analogue to the “2/
high speed” mode, but the operating
modes switch is not fixed.
- the unit will switch on only if all the re-
movable parts are installed properly
and the upper cover is fixed by the
clamps (7).
• Put the products only while the motor is
operating.
• Gradually put preliminary cut pieces of
the products into the throat (2) of the
cover (3) and slightly press them with
the pusher (1). Do not press strongly the
pusher; it can lead to worse quality of the
juice or to a stop of the shredding sieve
rotation (4).
• Do not immerse your fingers or other ob-
jects into the throat (2) of the cover (3).
• Periodically check the condition of the
shredding sieve (4) concerning blockage
of the filter, if necessary wash the shred-
ding sieve (4).
• Check the container (8), if it is full, switch
off the unit, take the plug out of the sock-
et, remove the container (8) and remove
the pressed skins.
• Check the juice tank (11); periodically
pour out the juice from it.
MW-1101.indd 4
MW-1101.indd 4
27.05.2009 9:40:48
27.05.2009 9:40:48
