4
ENGLISH
(Original instructions)
Attaching other accessories (Fig. A)
u
Align the lugs on the hose (8) with the recesses on the
accessory.
u
Press the accessory (10) onto the hose (8) and twist anti-
clockwise until the accessory clicks into place.
Note! The variable steam jet nozzle may be used without the
hose by fitting them directly to steam nozzle. All other acces-
sories must be connected to the hose for use.
Removing the hose and accessories(Fig. A & B)
Warning! The Steam nozzle, variable steam jet nozzle, hose
and accessories become hot during use. Allow the unit and all
accessories to cool before removing any accessories.
Removing an accessory (Fig. A)
u
Twist the accessory (10) clockwise then pull away from
the hose (8).
Removing the hose (Fig. A)
u
Press in the clips (9) on either side of the hose (8) and pull
away from the steam nozzle (11).
Removing the variable steam jet nozzle (Fig. B)
u
Press in the clips (11) on either side of the variable steam
jet nozzle (12) and pull away from the steam nozzle (11).
Filling the water tank (Fig. C)
This Steam cleaner incorporates an anti-calc system to help
prolong the life of the system.
Note: Fill the water tank with clean tap water.
Note: In areas of very hard water, the use of de-ionised water
is recommended.
u
Switch off the unit and disconnect from the mains supply.
u
Open the filler cap (4) by flipping it down.
u
Using the jug (6), fill the water tank (5) with water.
Warning! Your water tank has a 0.35 litre capacity.
u
Re-fit the filler cap (4).
Note: Ensure the filler cap is firmly secured.
Note: Do not use chemical cleaners with your steam mop..
Use
Switching on and off
u
To switch the appliance on, press the ON/OFF button (1).
It takes approximately 15 seconds for the hand held steam
cleaner to heat up.
Note: When the hand held steam cleaner is first turned on
the water reservoir will glow red. Once the hand held steam
cleaner is ready to use the water reservoir will glow blue.
u
Lift the lock off switch (2) and pull the trigger switch (3).
After a few seconds steam will be produced.
u
To switch the appliance off, release the trigger switch (3)
then press the ON/OFF button (1).
Caution! Always empty the hand held steam cleaner after
use.
Note: When first filled or after running dry it can take up to 45
seconds for steam to be produced.
Caution! Steam may continue to be produced for a short time
after the trigger switch (3) is released, this is normal. Switch
off and allow the unit to cool before removing any accessories.
Hints for optimum use
General
u
For optimal cleaning results never use the hand held
steam cleaner without first attaching an accessory.
u
Do not use chemical cleaners with your hand held steam
cleaner. To remove stubborn stains from vinyl or linoleum
floors, you can pre-treat with a mild detergent and some
water before using the steam mop.
Hand held steam cleaning
u
Attach the required accessory.
u
Connect the hand held steam cleaner to the mains.
u
Press the ON/OFF button (1). It takes approximately 15
seconds for the hand held steam cleaner to heat up.
u
Lift the lock off (2) and pull the trigger switch (3) to activate
the steam pump. After a few seconds steam will start to
come out of the accessory.
Note: When first filled or after running dry it can take up to 45
seconds for steam to be produced.
Note: During use you may turn off the steam pump by releas-
ing the trigger switch, this convenient feature will allow you to
place the hand held steam cleaner down for a short time so
that you may move items of furniture, then continue cleaning
without the need to switch the appliance off.
u
When you have finished using the hand held steam
cleaner, release the trigger switch (3), turn it ‘OFF’ and
disconnect from the mains supply. Wait until the steam
mop cools down before storing. (approximately five
minutes)
Caution! It is important to monitor the water level in the water
tank. To refill the water tank and continue to sanitise/clean,
turn the hand held steam cleaner ‘OFF’. Unplug the unit from
the electrical wall outlet, refill the water tank (5).
After use
u
Unplug the hand held steam cleaner from the electrical
wall outlet.
u
Allow the hand held steam cleaner to cool completely.
(approximately five minutes)
u
Empty the water tank (5).
u
Remove the accessories and store in the storage bag
provided.
