29
EN
at the end of the hose. When the
container is full, block the inlet of
the hose by replacing the plug. After
the container is emptied, repeat the
above procedure to drain the water in
the machine completely.
c. When draining of water is finished,
close the end by the plug again and
fix the hose in its place.
d. Turn the pump filter to take it out.
Discharging the water when the product
does not have an emergency draining
hose:
a. Place a large container in front of the
filter to catch water from the filter.
b. Loosen pump filter (anticlockwise)
until water starts to flow. Fill the
flowing water into the container
you have placed in front of the filter.
Always keep a piece of cloth handy to
absorb any spilled water.
c. When the water inside the machine is
finished, take out the filter completely
by turning it.
4. Clean any residues inside the filter as
well as fibers, if any, around the pump
impeller region.
5. Install the filter.
A
If your product has a water jet feature,
be sure to fit the filter into its housing
in the pump. Never force the filter
while installing it into its housing. Seat
the filter into its place completely.
Otherwise, water may leak from the
filter cap.
6. If the filter cap is composed of
two pieces, close the filter cap by
pressing on the tab. If it is one piece,
seat the tabs in the lower part into
their places first, and then press the
upper part to close.
