-
26
-
5.2 Installation of indoor unit
(1)
Installation of installation board
(a)
Fixing of installation board
(2)
Drilling the and installation of sleeve
(a)
Drill a hole with ø65
whole core drill
(b) Adjusting sleeve length (Option
parts)
(c)
Install the sleeve
(Inserting sleeve)
(*Sleeve + *Inclined + *Sealing plate)
Lock for the inside wall structures (Intermediate
support or pillar) and fairly install the unit after
level surface has been checked.
Adjustment of the installation
board in the horizontal direction
is to be conducted with four
screws in a temporary tightened
state.
Adjust so that board will be level
by turning the board with the
standard hole as the center.
Fixing on concrete wall
Use of nut anchor
Use of bolt anchor
Note (1) Drill a hall with incline of 5 degree from
indoor side to outdoor side.
Tapping Screws
Standard hole
Bolt
(M6
×
12)
Mounting
board
Nut
(M6)
Mounting
board
Max. 10
Indoor side
Outdoor side
Cut off the sleeve
collar in case of
drawing piping
out to rear.
Cut off the sleeve
collar that can be
seen from beneath
the unit.
Wall thickness
+ 1.5 cm
Indoor side
Outdoor side
Turn to
tighten
Paste
View of sleeve when installed
Inclined
flange
Sealing
plate
Sleeve
Indoor side
Outdoor side
Опубликовано TopClimat