23
Changing the battery
1. Loosen the thumbscrew at the front of the
pedal, then lift the pedal upwards to open
the unit.
* The thumbscrew can be left in the pedal
while changing the battery.
2. Remove the old battery from the battery
housing, and remove the battery snap con-
nected to it.
3. Connect the battery snap to the new bat-
tery, and place the battery inside the bat-
tery housing.
* Be sure to carefully observe the battery’s
polarity (+ versus -).
4. Slip the coil spring onto the spring base on
the back of the pedal, then close the pedal.
* Carefully avoid getting the snap cord
caught in the coil spring.
5. Finally, insert the thumbscrew into the
guide bush hole and fasten it securely.
When the CHECK indicator goes dim or no
longer lights while an effect is on, it means
that the battery is nearly dead and must be
replaced.
Replace the battery following the steps be-
low.
Thumbscrew
Pedal
Spring Base
Coil Spring
Guide
Bush
Hole
Battery
Housing
Battery Snap Cord
Battery Snap
9V Battery
