18
LIGHTING
ASSEMBLY AND REPLACEMENT
I
1. SPOTLIGHT
How to replace a square halogen light:
a) Check that the equipment is disconnected from the power supply.
b)
Open the panel completely till 90° (see figure)
pressing the PUSH button
c) Replace the lamp with a similar one (halogen, max 20 W, 12 Volt, G4 connection).
d) Close the panel. If the panel does not close correctly repeat the operation at point b.
2. GLASS LIGHTING
To replace the incandescent lamp:
1) ensure the hood is disconnected from the electric mains;
2) remove the decorative glass (see sec. O);
3) replace the lamp with one of the same model (max. 25W);
4) re-mount the glass (see fig. O5).
3. MIRABILIA LED LIGHTING
The hood is equipped with high efficiency, low power consumption LED lighting (light on
the work top and decorative light on the glass panes), with high durability under normal
use conditions. The LED spotlight must only be replaced by qualified technicians using
original spare parts.
WARNING: Do not remove the glass if the glass LED lighting is on.
MAINTENANCE AND CLEANING
L
Constant maintenance ensures the correct operation and efficiency of the appliance over
time. Special attention should be paid to the metal grease-trapping filters and the charcoal
filters. Frequent cleaning of the filters and their supports will ensure that fats and grease do
not accumulate on the range hood, with the consequent risk of fire.
1. METAL GREASE-TRAPPING FILTERS
These trap the fat and grease particles suspended in the air, and therefore should be
washed every month in hot water and detergent, without bending them. Wait until they
are completely dry before repositioning them. To remove and replace these filters, see
the instructions in point H1. This operation should be performed at regular intervals.
2. CHARCOAL FILTERS
These trap the odours present in the stream of air that passes through them. The air is puri-
fied by passing a number of times through the filters and being recirculated into the kitchen.
The charcoal filters cannot be cleaned, and should be replaced on average every 3-4 months
(according to use). To replace the charcoal filters, see the instructions in point H2.
3. CLEANING THE OUTSIDE OF THE APPLIANCE
It is advised to clean the external hood surfaces at least every 15 days in order to avoid that
oily or greasy substances affect the steel surfaces.