Power could be identified in accordance with below table:
Model
Size
Power, W
IR-6210
540mmx225mmx521mm
500/1000 W
IR-6211
700mmx225mmx521mm
750/1500 W
IR-6212
860mmx225mmx521mm
1000/2000 W
Important safeguards
Convection glass heater
2
3
Description
1. Display
2. Control panel
3. Power switch
4. Glass panel
5. Feet
5
4
1
2
Before use
Wall mounting
Free standing
Convection glass heater
1,2,3,4,5,6,7
– week days (Monday-
Sunday)
comfortable mode
economical mode
frost free mode
weekly mode
free mode
child lock
time
r
24 hour circle with each gap between
dots representing half an hour
temperature
heating indicator
Read carefully instruction manual before first use.
The heater becomes hot when it is working. Avoid contact with hot surface to prevent
burn.
Plug out heater when operate, clean or move it.
Do not use heater in rooms with high humidity.
Avoid ingress of water on the body.
Do not touch heater with wet hands. It can cause electric shock.
Do not cover heater when it is operating.
Do not place cord on the hot surface.
Use heater only in vertical position.
Do not switch on heater with damaged cord.
You should be very careful when the heater is used by children or disabled persons or
when it is used near them. Pay special attention when heater is switched on
unattended.
Do not use item near explosive and flammable substances.
Avoid placing foreign objects in air vents.
When you switch off the heater keep your hand on the plug and pull it, do not pull the
cord
Do not use item with damaged cord or plug.
If you find some defects, contact the nearest service center.
Save this instruction manual.
If heater is not mounted it should be set on the feet
Fix feet to the heater with screws as shown on the picture
Take the heater out of the box.
Make sure that item was not damaged during transportation.
Heater can be wall mounted or free standing.
Make sure that heater is plugged out.
There should be at least 50 cm above the heater and not less
than 15 cm between the bottom edge of the item and the floor.
Take out the wall brackets and expansion screws out of the
box and fix them on the wall as shown on the picture
Hang the heater on the wall
Fix it as shown on the picture
3 (on the back panel)
