WWW.APART-AUDIO.COM
2
1) Music level
2) Music source selector
3) Microphone mix level
4) Active led
1) Music level
2) Music source selector
3) Microphone mix level
4) Active led
5) Front XLR microphone connector
6) Minijack line input connector
7) Power on/off with control led
8) Local audio tone control
9) Local audio level
The APart PM1122R and PM1122RL remote control panels for PM1122 preamplifier have been designed to
fit into a standard in-wall box from BTicino. PM1122R fits into a 503E/NP box, PM1122RL fits into a 506E/
NP box. Mounting screws are provided with the remote panels.
PM1122R supports music level control, line source selection and microphone mix level control. PM1122RL
adds a dual local source input. This can be a microphone signal on the front XLR mic connector and/or a
stereo/mono line or headphone output on the front minijack connector. Headphone outputs from IPod’s,
portable MP3 players or computer line outputs are supported. Phantom power can be applied to the XLR
mic connector by setting a jumper at the rear of the PM1122RL. The local source level and tone can be set
on the PM1122RL front panel using the dedicated tone and level potmeters. Local source signal output is
always mono (stereo signals on minijack are mixed to mono line level). Press the front ‘power’ button so that
the power led lights up to allow input of local audio sources.
Connection between PM1122 and remote panel is made by a standard CAT5 cable wired according to
T-568B. Wire length can be up to 300 meters. Maximum wire length depends on multiple factors, such
as cable quality and external influence from high power lines etc. The ‘active’ led on the front (PM1122RL
only) lights up when the connected PM1122 preamplifier is switched to remote mode. You can use only one
PM1122R/RL per zone.
pm1122R
pm1122RL
1
2
3
4
5
6
7
8
9
1
2
3
4
