WWW.APART-AUDIO.COM
Safety First!
• Read all documentation before operating your equipment.
• Retain all documentation for future reference.
• Save the carton and packing material even if the equipment has arrived in good condition.
Should you ever need to ship the unit, use only the original factory packing.
• Do not spill water or other liquids into or on the unit.
• Make sure power outlets conform to the power requirements listed on the back of the unit.
• Do not use the unit if the electrical power cord is frayed or broken.
• Always operate the unit with the AC ground wire connected to the electrical system ground.
• Have gain controls on amplifiers turned down during power-up to prevent
speaker damage if there are high signal levels at the inputs.
• Do not connect the inputs / outputs of amplifiers or consoles to any other voltage source, such
as a battery, mains source, or power supply, regardless of whether the amplifier or console is
turned on or off.
• Power down & disconnect units from mains voltage before making connections.
• Do not use the unit near stoves, heat registers, radiators, or other heat producing devices.
• Do not block fan intake or exhaust ports. Do not operate equipment on a surface or in an
environment which may distort the normal flow of air around the unit. If the unit is used in an
Extremely dusty or smoky environment, the unit should be periodically “blown free” of dust.
• Do not remove the cover. Removing the cover will expose you to potentially dangerous volt-
ages.
• Do not drive the inputs with a signal level greater than that required to drive equipment to full
output.
• Do not run the output of any amplifier back into another input.
• Do not ground the red output terminal, never connect a red output terminal to another red
output terminal.
• In case of mal-function this device should be serviced by qualified service personnel only.
