USER’S MANUAL
7.7. Test
Under Utility Normal condition, push the “On” Switch for 3 seconds to execute the Battery Self-test function. In case the battery is normal,
it will enter into Battery Backup Mode for 10 seconds then return back to Utility Mode.
If the battery voltage is detected lower than set limit, the Battery Replacement LED will blink for 5 seconds then extinguish to stop self-test
procedure. And if battery is detected weak or dead, the Battery Replacement LED will steadily illuminate.
7.8. Connect Network Surge protection
Connect a 10 base-T/100 base-T network cable into the RJ-45 network surge protection “IN” jack on the rear of the UPS. Connect from
the “OUT” jack with network cabling to network equipment.
7.9. Replacing the Battery
Note:
Once the battery is disconnected, the loads are not protected from power outages.
When the Battery Replacement LED(Red) lights up, you may leave the UPS to be re-charged for at least 8~10 hours to see whether the
Red LED will be extinguished after the Self-test Function is executed again. In case the Red LED remains unchanged, you may unscrew
the Easy Swappable Battery cover, replace a new battery than push the “On” Switch to disable the RED LED.
Please follow the steps 1-7 to replace the new battery
8. UPS AUDIBLE ALARM
16
Øàã 2
Øàã 1
Øàã 3
Øàã 4
Øàã 5
Øàã 6
Øàã 7
IN
O UT
Indicator
Color
Description
Alarm
Utility Mode
Green
Steady:
Output Load is supplied by Utility
Blinking:
Polarity error or Ground Fault
None
Backup
Mode
Amber
Steady (with alarm):
Output Load is supplied by Battery
Blinking every 5 seconds (no alarm):
Stand by for Utility
recovery to restart up
Every 2 seconds before bat
tery Low and every 1 second
before battery Cutoff
Fault
Red
When Overload, short circuit, or
Output Voltage Abnormal occurs
Buzzer beeps continuously
Battery Re
placement
Red
Blinking:
Battery is weak and needs to be recharged
Steady:
Battery is dead
None
