10
3.3.3 GND Screw
GND is the supplementary grounding selection for other connected instruments.
33
32
3.3.2 POWER Switch
This switch turns the Mixer ON and OFF.
31
3.3.1 AC Inlet and Fuse Holder
3.3.4 The MAIN OUT
3.3.5 EFFECTS Send and Return
3.3.6 INPUT
3.3 The Rear Panel
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
WARNING: SHOCK HAZARD
AVIS: RISQUE DE CHOC ELECTRIQUE
- DO NOT OPEN
- NE PAS OUVRIR
PHONO
LINE
PHONO
LINE
TAPE
BOOTH
POWER
GND
L
R
GND
GND
MAIN OUT
INPUT 2
INPUT 1
INPUT 3
EFFECTS
PHONO
LINE
RETURN
TO MAIN
SEND
FROM PFL
AMP
PHONO
LINE
PHONO
LINE
PHONO
LINE
AC INPUT
EUROPE
210-240V
50Hz
Fuse:T315mAL
ON
OFF
MODEL
SERIAL
RATED POWER CONSUMPTION: 25W
Apparaten skall anslutas till
till ett natverk
jordat uttag nar den ansluts
Useonly
with
a250V
fuse
Useonly
with
a250V
fuse
Useonly
with
a250V
fuse
32
33
31
34
36
37
38
40
39
41
Use it to connect your DJM 4 to the Main AC with the supplied AC cord. Please check the Voltage available
in your Country and make sure the voltage is identical to the values marking on the product. Replace the fuse
with the same type by the qualified personnel only.
The AMP, BOOTH and TAPE outputs are RCA type connectors. Yes the same largely used in hi-fi and are low
impedance.
Through the AMP output (34), you can connect your DJM 4 to an amplifier, and the level will be controlled by
OUT A on the Top panel;
Through the BOOTH output (35), you can connect your DJM 4 to an additional amplifier and/or loudspeaker
system and the level will be controlled by OUT B on the Top panel;
Through the TAPE output (36), you can connect your DJM 4 to a tape recorder. The TAPE level is fixed, so you
should adjust the input level of the recorder.
You can send the PFL signal through the SEND (37) sockets to a signal processor such as reverb, equaliser,
etc.. Then from the same effect unit you bring the signal back into the DJM 4 via the RETURN (38) sockets
and the audio signal is routed into the MAIN output.
- PHONO input (39): The three Channels feature PHONO inputs including RIIA preamplifier for turntable. PIN
(RCA) jacks shall be used to connect the turntable.
- LINE input (40): Through these RCA type sockets you can connect a CD player, an MD player or any other
high level device such as Tape Recorder, DAT, etc..
Important Notice:
If you wish to connect LINE level devices into the LINE/PHONO input, make sure that the
LINE/PHONO switch (41) is on LINE position otherwise the sensitive RIAA preamplifier built-in in the Phono
input will be overloaded and will produce distortion.
USA / Canada
100-120V
60Hz
Fuse:T500mAL
UK / Aust
240V
50Hz
Fuse:T315mAL
35
