• 11 •
English
8 STEAM
/
CAPPUCCINO
Danger of scalding! Dispensing may be preceded
by small jets of hot water. The wand can reach
high temperatures: Do not touch it directly with bare
hands.
• Press the ON/OFF button (11) and switch it to the "I"
position.
• Wait until the "machine ready" (20) light turns on.
•
(Fig.25) -
Set the selection knob (17) to the "
" position.
The light (20) turns off .
• Wait until the light (19) turns on. The machine is now ready
for steam dispensing.
•
(Fig.26) -
Place a container under the steam wand.
•
(Fig.26) -
Open the knob (3) for a few seconds, so that
remaining water fl ows out of the steam wand (Pannarello).
In a short time only steam will come out.
•
(Fig.27)
-
Close the knob (3) and remove the container.
• Fill 1/3 of the container you wish to use to prepare
cappuccino with cold milk.
Use cold milk to get a better result.
•
(Fig.28) -
Immerse the steam wand in the milk and open
the knob (3) by turning it counter-clockwise. Turn the milk
container with slow upward movements so that it warms
up evenly.
A maximum dispensing of 60 seconds is
recommended.
• Once fi nished, close the knob (3) by turning it clockwise
and remove the cup with frothed milk.
•
(Fig.30) -
Set the selection knob (17) to the " " position.
If both "
" and "
" lights are on, the temperature of
the machine is too high for brewing coff ee.
• Prime the circuit as described in Section 4.5 to make the
machine ready for use.
Note: The machine is ready when the "machine
ready" light
is permanently on.
Important Note: If it is not possible to brew
cappuccino as described, prime the circuit as
explained in Section 4.5 and then repeat the steps.
The same procedure can be performed to heat
other beverages.
• After this operation, clean the steam wand with a wet
cloth.
9 CLEANING
Maintenance and cleaning can only be carried out when the
machine is cold and disconnected from the electrical network.
• Do not immerse the machine in water or place any of its
parts in a dishwasher.
• Do not use spirit, solvents and/or aggressive chemical
agents.
• We recommend cleaning the water tank and refi lling it
with fresh water daily.
•
(Fig.31-33) -
Every day, after heating milk, remove the
external part of the Pannarello and wash it with fresh
drinking water.
•
(Fig.31-32-33) -
Clean the steam wand weekly. To do this,
the following operations have to be performed:
- Remove the external part of the Pannarello (for standard
cleaning);
- Remove the upper part of the Pannarello from the steam
wand;
- Wash the upper part of the Pannarello with fresh drinking
water;
- Wash the steam wand with a wet cloth and remove any
milk residues;
- Reposition the upper part in the steam wand (make sure
it is completely inserted).
Reassemble the external part of the Pannarello.
•
(Fig.34) -
Empty and clean the drip tray every day.
• Use a soft, dampened cloth to clean the appliance.
•
(Fig.20) -
Perform the following operations to clean the
pressurized fi lter holder:
-
(Fig.9)
- Remove the fi lter and wash it thoroughly with
hot water.
- Remove the adapter (if fi tted) and wash it thoroughly
with hot water.
- Wash the internal part of the pressurized fi lter holder.
• Do not dry the machine and/or its components using a
microwave and/or standard oven.
•
(Fig.35-36) -
Clean the seat for accessories with a damp
cloth every week to remove any coff ee or dust residues.
Note: Do not wash the pressurized fi lter holder
in the dishwasher.
