10
Studiophile BX10s Deluxe Subwoofer
Setting Up the SBX10 Subwoofer
Connecting the Power
AC Voltage Select:
Since the SBX10 subwoofer contains its own amplifier, it must be connected to a
power outlet using the detachable AC cable provided. Note that the AC Voltage Select switch (located
below the IEC socket for the mains power cord) is user-selectable for 100-120V~50/60 Hz or
220-240V~50/60Hz operation. Before you do anything, make sure the AC Voltage Select switch is set
to the appropriate position for your location. Then connect the included AC cable.
Warning:
Use of improper voltage/selector switch combinations may result in hazardous conditions and/or
damage to speaker components not covered by speaker warranty.
Connecting Audio
2-Channel Stereo Operation:
Connect the main left and right outputs of your mixing console, audio
interface, or sound card to the XLR or TRS balanced inputs or RCA unbalanced inputs on the back of
the SBX10 subwoofer; then route the subwoofer’s left and right XLR or TRS balanced outputs to your
direct-field, full-range monitors. (While the TRS inputs and outputs will work with unbalanced cables,
we strongly recommend you use balanced cables. In doing so, you will have better immunity to induc-
tively coupled noise from power cables, etc.)
XLR PIN 1 and TRS sleeve = signal ground (shield)
XLR PIN 2 and TRS tip = signal positive (+)
XLR PIN 3 and TRS ring = signal negative (–)
5
/
2XWSXWV
5
/
,QSXWV
5LJKW
2XWSXW
/HIW
2XWSXW
5LJKW
/HIW
