■
Cables
Use speaker cable with 1/4” plugs. If you use a cable that is not
designed as a speaker cable, the cable itself may overheat or
catch fire. If a malfunction occurs in the cable, the amp head may
overheat and malfunction.
■
Impedance
When connecting the speaker system to an amp, please check the
total impedance of the speaker system that you are connecting. In
particular when connecting multiple speakers, the impedance of the
entire system will be less than the impedance of a single speaker
cabinet. When setting up, it is important to match the impedance with
the amp. Please set up your system according to the connection
examples shown in this manual. If you are unsure about how to make
connections, please contact your dealer.
■
Power handling
When connecting the speaker system to an amp, you must check the
output rating of the amp. If a signal that is larger than the rated power
handling is input to a speaker unit, the speaker unit may be damaged.
If this occurs, a fee will be charged to replace the speaker unit even if
the system is still under warrantee.
■
Cable connections
Before you connect cables, turn the power off. If the speaker is
repeatedly subjected to the noise that occurs when a plug is inserted
or removed, wires may break or other malfunctions may occur.
■
Care of the cabinet
To prevent the cabinet from becoming discolored or deformed, avoid
using it in direct sunlight or extreme humidity. To remove dust or dirt,
wipe gently with a dry cloth. Do not use alcohol, petrochemical
solvents, or thinner, since these may discolor the cabinet.
This product was carefully inspected before it left the factory. If you
experience any problem during operation, please consult the dealer
where you purchased the product. So that servicing can be performed
without unnecessary delay, please describe the problem in detail.
Specifications and appearance of this product are subject to change
without notice for improvement.
■
Speaker cabinet location
If you use your system with the head amp placed on top of the ------
Precautions during use
1/4” plug
In the case of defects
Utiliser exclusivement des câbles destinés à des enceintes et équipés en
jacks 1/4 ”. Si vous utilisez un câble non conçu pour être relié à un haut
parleur, celui-ci peut surchauffer et même s’enflammer. Si le câble n’est pas
conçu pour relier un baffle, il peut également provoquer une surchauffe de la
tête d’ampli et un défaut de fonctionnement.
Avant de brancher les câbles, mettez l’ampli hors tension. Si vous
soumettez fréquemment l’enceinte au bruit provoqué par le
branchement/retrait d’un câble, cela risque de rompre des fils ou de
provoquer d’autres disfonctionnements.
Benutzen Sie ausschließlich ein Boxenkabel mit 1/4” Klinkenanschluss.
Andere, nicht als Boxenkabel gekennzeichnete Kabel, können überhitzen
und im schlimmsten Falle ein Feuer entfachen.
Ein defektes Boxenkabel kann zur Überhitzung und zum Schaden des
Verstärkers führen.
Vor dem Anschließen der Kabel müssen Sie den Verstärker ausschalten.
Wenn die Lautsprecher häufig dem lauten Geräusch ausgesetzt sind, das beim
Aus- oder Einstecken der Stecker entsteht, kann der Lautsprecher Schaden
nehmen.
