6
ENGLISH
•
Avoid contact of heated surfaces with your face, neck and
other parts of your body.
Note:
– Do not touch the operating surface during the unit opera-
tion.
– During the first operation some foreign smell and a small
amount of smoke from the operating surfaces is possible,
this is normal.
– During breaks in operation, place the unit on a flat heat-
resistant surface.
•
After you finish using the unit set the power switch (5)
to the «
O
» position (the unit is switched off), the power
indicator (4) will go out and then you can unplug the unit.
Let the unit cool down.
HAIR CURLING
For hair curling use the outer surface of the heating plates (10).
Press the heating plates (10) together and move the clamp
(8) away from the handle (6) to fix them. So they create the
solid operating surface allowing to use the unit for hair curling.
To get the best results, wash your hair with shampoo, wipe it
with a dry towel, dry with a hairdryer and comb your hair. After
that you can start styling your hair.
•
Divide the hair into locks 4-5 cm wide.
•
Insert the power plug into the mains socket.
•
Set the power switch (5) to the «
I
» position (the unit is
switched on), the power indicator (4) will light up.
•
Place the unit on a flat heat-resistant surface and let it
heat up.
•
Take a hair lock with the free hand.
•
Lift the clamp (2) by pressing the clamp handle (3).
•
Place the end of the lock on the outer surface of the heat-
ing plates (10) and bring the clamp (2) down.
•
Wind the lock around the heating plates (10).
•
Wait for a while, then press the clamp handle (3) and
release the hair lock.
•
Repeat this procedure on the rest of your hair.
Note:
– Do not comb your hair right after styling, let it cool off.
Divide big locks into smaller ones carefully to make the
hairstyle look natural.
•
After finishing the hairstyling procedure switch the unit
off by setting the switch (5) to the position «
O
» (the unit is
switched off), the indicator (4) will go out.
•
Remove the power plug from the mains socket.
•
Place the unit on a flat heat-resistant surface and let it cool
down completely.
IM VT-8424.indd 6
28.06.2016 17:12:54
