IR-
2400
IR-2400
4
5
HOW TO ASSEMBLE AND USE
1) Attach head to body.
2) Secure head with the small Head Screw until it is fully tightened.
3) Insert handle down into the body.
4) Once the handle is placed inside the body, Please make sure is already located on the handle to
the
bottom.
5) Screw the Large
Head screw through the opening at the back of the body into the rear of the
handle, tighten with screwdriver until secure .
6) Place the Microfiber Cloth Pad or disposable pad (optional item) onto the mop head.
Note: Microfiber Cloth is washable while the disposable pad (optional item) is intended for one-
time use.
7) Fasten the Microfiber Cloth Pad by pulling the cord while pressing on Toggle. Note: this step is
not required if you are using disposable pad (optional item). Disposable pad comes with built in
elastic cord .
8) When using Steam Mop on carpets, place the mop head (with microfiber cloth or disposable
pad in place) over the Carpet Glider.
9) To remove the Water tank push it up and detach from the body as shown below.
10) Please pour two measuring cups of water into the Water tank (The MAX is 800ml, do not try to
over fill).
11) Twist the Quick Release Cord Wrap clockwise to unwrap the Power Cord completely and plug
into a grounded outlet.
12) When plugged in, the LED light located on the front of the Steam Mop body will be red. After
20-25 seconds,it mean the mop is ready to release steam.To release steam,press the trigger
located on the handle, and the unit will start releasing steam. To stop releasing steam, press the
trigger again.
CAUTION:
To sanitize an area of your floor, leave the Steam Mop over area for a minimum of 8
seconds, but no longer than 15 seconds. Leaving the Steam Mop in a stationary position for a
longer period than recommended may cause the build up of a pale residue. This residue can be
removed by using a decalcifying product or with a few drops of vinegar. (See troubleshooting
guide)
NOTE:
It is recommended that another high wattage appliance is not operated on the same circuit
to avoid a circuit overload.
13) When the Steam Mop stops emitting steam, this will occur after approximately 20 minutes of
use, turn off the Steam Mop and simply remove the Water tank, refill, and then again turn on and
continue cleaning.
WARNING:
NEVER run the Steam Mop without water. NEVER direct steam at any person or
animal. Use the Steam Mop on sealed hard floor only.
14) When you finish your cleaning, unplug Power cord from outlet, empty the Water tank, carefully
remove the cloth Pad from the head, wind Power Cord around the Cord Wrap and store it upright in
a dry area or hang by the storage hook.
CAUTION:
The Cloth Pad may be very hot.
Not for space heating purpose.